Gebäude
Einzelhandel
Unternehmen
Flughafen
Bank
Casino
Industriepark
Campus
Einkaufszentrum
Autobahn
Gesundheitswesen
Seehafen
Temperaturüberwachung
Aktuelles
Veranstaltungen
Erfolgsgeschichten
Videos
Abonnent
Tools
Nutzungsbedingungen
Download-Center
Produktlizenzierung
Fälschungsschutz-Abfrage
Unser Unternehmen
Partner
Karriere
Kontakt
Online-Anfrage
Impressum
Sicherheitszentrale
Managementsystem
Answer:
Set wiper parameters before you can control the wiper.
Note: Note: Only some certain models support this function. Please see the actual model for details.
1. Click Setup > System > Ports & Devices, and then click the External Device tab.
2. Set control mode for the wiper. The following table describes some major parameters.
| Parameter | Description |
|---|---|
| Serial Port | The wiper is controlled by PELCO-D instructions; therefore, the PTZ protocol should be set to PELCO-D. See PTZ control for details. |
| Alarm Input/Output | Use alarm input and output to open or close the circuit and control the wiper. |
浙公网安备 33010802004032号